Home · Laboratory

A hose is born three times.

3 cyclesBefore production
116.8 to 151.9 barFirst-carcass burst
6 capabilitiesAll in-house
100% of batchesIn-house final acceptance

Before going into production, every new hose goes through three full cycles in the Flexomarine laboratory: compound validation, layer prototyping and destructive testing. The rubber compound is developed in-house, not bought from third parties.

Compounding e fabricacao
01
Compound validation

The rubber compound, the soul of the product, is developed in-house. Our own elastomer chemistry and mixing (compounding) validate each formulation before the line.

Prototipagem e bobinamento
02
Layer prototyping

Every new geometry is born as a prototype: the layer is built and tuned until standard and test match. Prototypes qualified by bore (12″/24″, single and double carcass).

Teste destrutivo / burst
03
Destructive testing

The hose is taken to failure. First-carcass burst from 116.8 to 151.9 bar (above the GMPHOM 2009 minimum of 104), nipple adhesion > 10 N/mm, hydrostatic per GMPHOM 2009.

In-house capabilities
The whole chain in one address.
Compounding própriorubber mixing
Salas de testeresistance and durability testing
Paletização internaown steel pallets
Pinturain-house finishing
Final Acceptance Testingin-house FAT · 100% of batches
P&Dnew technologies in-house
Transparency starts in the lab. We publish the test results, from burst to adhesion.
See the test protocols →